need help how to remove factory radio....03 rsx!!

**jdmhead** · 05-30-2007, 04:16 PM

i need help!!!! if n e one knows can u please help me out!! thanx!

**Ashy Larry** · 05-31-2007, 01:08 AM

lmk... i have the day off wednesday and can help you out.

**jdmhead** · 05-31-2007, 01:31 AM

thanks but i was doing it for this customer so ill told him 2 do so that way he was responsible for it...but thanks alot!!!

**Ashy Larry** · 05-31-2007, 10:52 AM

that was the best decision... the "foamy" material that surrounds the radio bezel is subject to "ripping" and they'd probably try to blame you for it since it's impossible to get out without bending it a little.

**jdmhead** · 06-03-2007, 12:12 AM

yea i dont quite understand that foamy ishhh....were you able to remove yours?

**Taylor** · 06-03-2007, 12:14 AM

With the dashes on most hondas, if you sldie the seats all the way back, theres screws there on the sides of that um...middle section. you undo those, and the whole **** lifts up...

**jdmhead** · 06-03-2007, 03:38 PM

I Kno Wat Ur Saying Ill Jus Reffer Him To Audio Fashion Over There In Front Of Greenwayford...does Any One No How They Do??

**dxplayxr** · 06-03-2007, 11:09 PM

i kno how u jus pik up u lil nextel an call audiozone an the skinny hindu guy will help u

**jdmhead** · 06-04-2007, 11:51 AM

wrd g money

**Dj Z** · 06-04-2007, 01:21 PM

there HAS to be some theives on here that should be able to help with the removal of a radio!

**n2oef** · 06-04-2007, 01:26 PM

big flathead screwdriver,hammer,and full coverage insurance?

**Ashy Larry** · 06-05-2007, 10:40 AM

Originally Posted by jdmhead

yea i dont quite understand that foamy ishhh....were you able to remove yours?

yep... easy stuff

**Bryan200sx** · 06-05-2007, 09:37 PM

it takes 15 min....

on top of the little flip tray there is a panel that comes off pry the edges carefully.Once its off there should be 2 10mm scrws w/ a philps tip on the top, use an angle driver or a snubby screwdriver to get it out.

pull the radio from the back just enough to pop a corner of the plasic trim with the hazard lights on it. Work the outside till all the clips pop off. 4 to 6 if i remember correctly.

Should take you about 20 if doing it for the 1st time.

(not a theif. im an installer)